axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 26260 - Block : Collision of the two protection areas and
The two protection areas named collide in the indicated block, i.e. the distance between the two protection areas is smaller than the value defined by MD10619 $MN_COLLISION_TOLERANCE Control reaction: Correction block is reorganized. Alarm display. NC Stop on alarm.
26260
Siemens 26260 - Block : Collision of the two protection areas and
Block: Collision of the two protection areas and
The two protection areas named collide in the indicated block, i.e. the distance between the two protection areas is smaller than the value defined by MD10619 $MN_COLLISION_TOLERANCE Control reaction: Correction block is reorganized. Alarm display. NC Stop on alarm.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The two protection areas named collide in the indicated block, i.e. the distance between the two protection areas is smaller than the value defined by MD10619 $MN_COLLISION_TOLERANCE
Troubleshooting Steps
- 1Change NC program or definition of the protection areas involved.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.