axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 20-45 minutes
Siemens 26266 - Block : The protection area with the name was programmed
The name of a protection area was programmed several times (e.g, during the function call PROTA) Control reaction: Correction block is reorganized. Alarm display. NC Stop on alarm.
26266
Siemens 26266 - Block : The protection area with the name was programmed
Block: The protection area with the name was programmed
The name of a protection area was programmed several times (e.g, during the function call PROTA) Control reaction: Correction block is reorganized. Alarm display. NC Stop on alarm.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The name of a protection area was programmed several times (e.g, during the function call PROTA)
Troubleshooting Steps
- 1Indicate each required name of a protection area only once.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.