axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 26256 - Block : The protection area group referred to in
The protection area group to be added to the current protection area group was not found Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
26256
Siemens 26256 - Block : The protection area group referred to in
Block: The protection area group referred to in
The protection area group to be added to the current protection area group was not found Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The protection area group to be added to the current protection area group was not found
Troubleshooting Steps
- 1Indicate in $NP_ADD_GROUP[...] the name of an existing protection area group, define a protection area group with the name indicated or delete entry.
- 2Clear alarm with NC START or RESET key and continue the program. Continuation: Alarms
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.