axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 26224 - Block : The names of the protection area elements $NP_NAME[ ]
Two protection area elements were assigned the same name. The names of the protection area elements must be clear and identifiable Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
26224
Siemens 26224 - Block : The names of the protection area elements $NP_NAME[ ]
Block: The names of the protection area elements $NP_NAME
Two protection area elements were assigned the same name. The names of the protection area elements must be clear and identifiable Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- Two protection area elements were assigned the same name.
- The names of the protection area elements must be clear and identifiable
Troubleshooting Steps
- 1Rename one of the protection area elements involved.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.