axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 26234 - Block : The protection area $NP_PROT_NAME[ ] does not contain
A protection area must contain at least one protection area element Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
26234
Siemens 26234 - Block : The protection area $NP_PROT_NAME[ ] does not contain
Block: The protection area $NP_PROT_NAMEdoes not contain
A protection area must contain at least one protection area element Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- A protection area must contain at least one protection area element
Troubleshooting Steps
- 1Change definition of protection area or delete protection area.
- 2Clear alarm with NC START or RESET key and continue the program. Continuation: Alarms
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.