axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 17090 - Block value exceeds upper limit
An attempt was made to write into a machine data with a value greater than the defined upper limit Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
17090
Siemens 17090 - Block value exceeds upper limit
Block value exceeds upper limit
An attempt was made to write into a machine data with a value greater than the defined upper limit Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- An attempt was made to write into a machine data with a value greater than the defined upper limit
Troubleshooting Steps
- 1Please inform the authorized personnel/service department.
- 2Determine the input limits of the machine data and assign a value within these limits.
- 3Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.