Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-60 minutes

Alarm 17140

Siemens 17140 - Block NCK output is assigned to a function via machine data

The programmed digital/analog output is assigned to an NC function (e.g. software cams) Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.

Siemens SINUMERIKProgram/G-codeIntermediate30-60 minutes

17140

Siemens 17140 - Block NCK output is assigned to a function via machine data

Block NCK output is assigned to a function via machine data

The programmed digital/analog output is assigned to an NC function (e.g. software cams) Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The programmed digital/analog output is assigned to an NC function (e.g. software cams)

Troubleshooting Steps

  1. 1Please inform the authorized personnel/service department.
  2. 2Use another output or deactivate concurrent NC function via MD.
  3. 3Clear alarm with NC START or RESET key and continue the program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.