axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 20-40 minutes
Siemens 14752 - Block DELDTG | STOPREOF conflict
In a block of motion synchronous actions referring to a motion block, both DELDTG (delete distance-to-go) and STOPREOF (preprocessing stop) have been programmed Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
14752
Siemens 14752 - Block DELDTG | STOPREOF conflict
Block DELDTG | STOPREOF conflict
In a block of motion synchronous actions referring to a motion block, both DELDTG (delete distance-to-go) and STOPREOF (preprocessing stop) have been programmed Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- In a block of motion synchronous actions referring to a motion block, both DELDTG (delete distance-to-go) and STOPREOF (preprocessing stop) have been programmed
Troubleshooting Steps
- 1The functions DELDTG and STOPREOF exclude each other in a block.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.