axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Basic · 10-20 minutes
Siemens 14144 - Block PTP movement not allowed
The PTP G code was programmed for a movement other than G0 or G1 Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
14144
Siemens 14144 - Block PTP movement not allowed
Block PTP movement not allowed
The PTP G code was programmed for a movement other than G0 or G1 Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The PTP G code was programmed for a movement other than G0 or G1
Troubleshooting Steps
- 1Modify the program.
- 2Clear alarm with the RESET key. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.