Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 14140

Siemens 14140 - Block position programming without transformation not allowed

Position information was programmed for an axis position but no transformation was active Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

14140

Siemens 14140 - Block position programming without transformation not allowed

Block position programming without transformation not allowed

Position information was programmed for an axis position but no transformation was active Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • Position information was programmed for an axis position but no transformation was active

Troubleshooting Steps

  1. 1Modify the program.
  2. 2Clear alarm with the RESET key. Restart part program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.