100006

Press the RECALL key or acknowledge button to clear the informational message from the display.

Verify the edited program block appears correctly in the program editor by scrolling to the modified line.

If continuing to edit, proceed with next modification. If finished, exit the editor and save the complete program.

Perform a program test run or simulation to verify the stored block executes as intended before production use.

Always verify critical program changes in single block mode before automatic operation.

Acknowledge the message using the RECALL key to clear the display.

Verify on the screen that the cursor or program pointer is positioned at the correct block number for restart.

Check machine position and modal conditions (G-codes, tool offsets, coordinate systems) match the requirements for the stored block.

Incorrect repositioning can cause collisions. Verify all axes positions before restarting.

Execute program restart using CYCLE START, preferably in single block mode for first block verification.

Clear the informational message by pressing RECALL. The DNC operation should continue automatically.

Monitor the program transfer interface to ensure data communication is stable and no transmission errors occur.

If messages appear repeatedly during transfer, check communication settings (baud rate, protocol, handshaking) in the system configuration.

After transfer completes, verify program integrity by checking file size and performing syntax check in the program manager.

Incomplete or corrupted program transfers can cause unexpected machine behavior or crashes.