axismd.ai
KUKA Robot Controller
Overheat/Thermal · Basic
KUKA Robot KRC0236 - Mainboard temperature check not available
This alarm indicates that the KRC controller's main processing board lacks integrated temperature monitoring capability or the temperature sensor interface is not functional. The system cannot perform real-time thermal monitoring of the motherboard, which may prevent proper overheat protection mechanisms from operating. This condition is typically specific to older KRC controller hardware revisions that were manufactured without embedded thermal sensing components.
KRC0236
KUKA Robot KRC0236 - Mainboard temperature check not available
Mainboard temperature check not available
This alarm indicates that the KRC controller's main processing board lacks integrated temperature monitoring capability or the temperature sensor interface is not functional. The system cannot perform real-time thermal monitoring of the motherboard, which may prevent proper overheat protection mechanisms from operating. This condition is typically specific to older KRC controller hardware revisions that were manufactured without embedded thermal sensing components.
Common Causes
- Motherboard hardware revision does not include temperature monitoring sensor
- Temperature sensor connector is disconnected or unseated on the main PCB
- Defective or failed temperature monitoring chip on the motherboard
- Firmware/software version mismatch incompatible with hardware sensor interface
- Corrupted BIOS or controller configuration settings affecting sensor detection
Troubleshooting Steps
- 1Verify the KRC controller hardware revision and cross-reference technical documentation to confirm if temperature monitoring is supported for this model
- 2Power down the robot controller and inspect the motherboard for any disconnected thermal sensor connectors or visible hardware damage
- 3Reseat all internal connectors on the main PCB, particularly those connected to power management and sensor circuits
- 4Check the current KRC firmware version and update to the latest available release that matches your hardware revision
- 5Access the controller system settings and verify that temperature monitoring is enabled in BIOS or boot configuration menu
- 6If alarm persists after verification steps, contact KUKA service for motherboard replacement or hardware upgrade assessment
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.