235-00A1

Access MOD Parameters

Navigate to Setup → General → Machine Parameters → MOD and check the HSCI configuration parameters for the reported address %3.

Document current MOD settings before making changes for easy rollback.

Verify Physical Module Type

Check the actual module type installed at HSCI slot position matching address %3 and compare with the alarm's Hardware: %2 information.

Power down the control before inspecting HSCI modules to prevent damage.

Correct MOD Configuration

Update the relevant MOD parameters to match the physical hardware configuration, then perform a control restart to reinitialize the HSCI system.

Power Down System

Safely shut down the TNC control and disconnect power to the HSCI system before handling any modules.

Always follow proper ESD procedures when handling HSCI modules.

Identify Correct Module

Reference the machine documentation or Setup → General → Machine Parameters → MOD to determine the correct module type that should be installed at the reported position.

HSCI module part numbers are typically printed on a label on the module itself.

Replace Module

Remove the incorrect module from the HSCI slot and install the proper module type as specified in the projection.

Ensure module is fully seated and locking mechanism is properly engaged.

Verify Installation

Power up the system and check that the alarm clears and the HSCI device %4 with serial number %5 is properly recognized.

Check HSCI Address Settings

Navigate to Setup → General → Machine Parameters and verify HSCI address assignments match the physical slot positions.

HSCI addresses typically start from 0 and increment sequentially.

Verify Physical Addressing

Check the physical HSCI module positions and ensure they correspond to the configured addresses in the machine parameters.

Reconfigure Addressing

Correct the HSCI address parameters to match the actual physical module layout and restart the control system.

Backup Current Configuration

Create a backup of current machine parameters via Setup → General → Data Transfer before attempting any restoration procedures.

Reset HSCI Configuration

Navigate to Setup → General → Machine Parameters → MOD and reset HSCI-related parameters to default values.

Resetting parameters may affect other system functions - have original parameter backup available.

Reconfigure HSCI System

Manually reconfigure the HSCI parameters to match the actual hardware installation and perform a complete system restart.

Test System Function

Verify all HSCI-connected devices function properly after reconfiguration and monitor for recurring alarms.