Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 20-45 minutes

Alarm 61900

Siemens 840D 61900 - Channel block: No contour available

Siemens SINUMERIK alarm 61900: Channel block: No contour available. This alarm indicates a fault or error condition on the SINUMERIK 840D control. Refer to the Siemens SINUMERIK alarm documentation for the complete description and remedy.

Siemens SINUMERIKServo/AxisIntermediate20-45 minutes

61900

Siemens 840D 61900 - Channel block: No contour available

Channel block: No contour available

Siemens SINUMERIK alarm 61900: Channel block: No contour available. This alarm indicates a fault or error condition on the SINUMERIK 840D control. Refer to the Siemens SINUMERIK alarm documentation for the complete description and remedy.

Safety

  • Refer to Siemens documentation
  • Ensure qualified technician performs repairs

Common Causes

  • Parameter or machine data configuration error
  • Hardware fault on the NC or drive component
  • Part program error or illegal command
  • Communication fault between NC and drive or I/O modules
  • Software or firmware error requiring system restart

Troubleshooting Steps

  1. 1Note the complete alarm text including any axis, channel, or block number values.
  2. 2Check for related alarms active simultaneously in the SINUMERIK alarm list.
  3. 3Power cycle the machine to clear transient faults.
  4. 4Review the SINUMERIK machine data for parameters related to the alarm.
  5. 5Consult the Siemens SINUMERIK alarm manual for alarm 61900 detailed remedy.

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.