Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 30-60 minutes

Alarm 61532

Siemens 840D 61532 - Channel block: Value for _LAGE is incorrect

The alarm can be triggered by the following grinding cycle: CYCLE414 Remedy: Correct parameter content for _LAGE

Siemens SINUMERIKServo/AxisIntermediate30-60 minutes

61532

Siemens 840D 61532 - Channel block: Value for _LAGE is incorrect

Channel block: Value for _LAGE is incorrect

The alarm can be triggered by the following grinding cycle: CYCLE414 Remedy: Correct parameter content for _LAGE

Safety

  • Refer to Siemens documentation
  • Ensure qualified technician performs repairs

Common Causes

  • Incorrect _LAGE parameter value in CYCLE414 grinding cycle definition
  • Data type mismatch or out-of-range value assigned to _LAGE variable
  • Corrupted or incomplete cycle program syntax affecting parameter passing
  • Machine zero offset or workpiece positioning data incompatible with _LAGE specification

Troubleshooting Steps

  1. 1Verify CYCLE414 program source code and check _LAGE parameter declaration against machine documentation for valid range and data type requirements
  2. 2Review the specific block number indicated in the alarm message and trace parameter assignment logic leading to that block
  3. 3Cross-reference _LAGE value with active machine configuration, coordinate system setup, and any linked offset tables
  4. 4Test with known working CYCLE414 program variant to determine if issue is program-specific or system-wide
  5. 5Clear alarm, re-initialize cycle parameters, and re-execute program with corrected _LAGE values

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.