What causes Siemens SINUMERIK alarm 61510?

Test run feed mode is enabled in the CNC control panel during active grinding cycle execution. Operator activated single-block or test run feed mode before or during CYCLE410, CYCLE411, CYCLE413, CYCLE415, or CYCLE420. Machine parameters for test run feed are not properly configured or disabled after previous maintenance/setup. Program control logic conflict where test run feed flag remains set from interrupted or previous cycle.

How do I fix Siemens SINUMERIK alarm 61510?

1. Check the CNC control panel display for active test run feed indicator and manually disable test run feed mode using the appropriate softkey or control button 2. Stop the current program execution and verify that single-block and test run feed modes are both deactivated before restarting the grinding cycle 3. Review the active grinding cycle (CYCLE410, CYCLE411, CYCLE413, CYCLE415, or CYCLE420) in the part program and confirm test run feed is not being called within the cycle logic 4. Reset the channel by pressing the reset button and clear any latched alarm states before attempting to restart the program 5. If issue persists, check machine parameter settings related to test run feed conditions and consult the machine builder documentation for proper configuration reset procedures

Siemens SINUMERIK codes

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Basic · 5-15 minutes

Alarm 61510

Siemens 840D 61510 - Channel block: Test run feed is active

The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE413, CYCLE415, CYCLE420 Remedy: Switch off test run feed

Siemens SINUMERIKServo/AxisBasic5-15 minutes

61510

Siemens 840D 61510 - Channel block: Test run feed is active

Channel block: Test run feed is active

The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE413, CYCLE415, CYCLE420 Remedy: Switch off test run feed

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Common Causes

Test run feed mode is enabled in the CNC control panel during active grinding cycle execution
Operator activated single-block or test run feed mode before or during CYCLE410, CYCLE411, CYCLE413, CYCLE415, or CYCLE420
Machine parameters for test run feed are not properly configured or disabled after previous maintenance/setup
Program control logic conflict where test run feed flag remains set from interrupted or previous cycle

Troubleshooting Steps

1Check the CNC control panel display for active test run feed indicator and manually disable test run feed mode using the appropriate softkey or control button
2Stop the current program execution and verify that single-block and test run feed modes are both deactivated before restarting the grinding cycle
3Review the active grinding cycle (CYCLE410, CYCLE411, CYCLE413, CYCLE415, or CYCLE420) in the part program and confirm test run feed is not being called within the cycle logic
4Reset the channel by pressing the reset button and clear any latched alarm states before attempting to restart the program
5If issue persists, check machine parameter settings related to test run feed conditions and consult the machine builder documentation for proper configuration reset procedures

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.