What causes Siemens SINUMERIK alarm 61441?

Tool carrier orientation has shifted the cutting edge position outside the machining plane during CYCLE982 execution. Incorrect tool offset values stored in the tool table for the active tool. Tool carrier mechanical wear or looseness causing unintended position deviation. Spindle orientation or tool holder seating issue resulting in cutting edge misalignment.

How do I fix Siemens SINUMERIK alarm 61441?

1. Verify tool carrier orientation is correct and mechanically secure; inspect for wear or looseness in the tool holder interface 2. Check active tool offset values in the tool table and compare against physical tool geometry measurements; update offsets if necessary 3. Re-run CYCLE982 measuring cycle after ensuring tool is properly seated and spindle orientation is at expected position 4. Review NC program block containing the alarm trigger and verify cutting edge position matches the defined machining plane geometry 5. If using an oriented tool carrier, confirm orientation angles match program specifications and recalibrate tool position if needed

Siemens SINUMERIK codes

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 30-60 minutes

Alarm 61441

Siemens 840D 61441 - Channel block: Position of cutting edge is not in the machining

The alarm can be triggered by the following measuring cycle: CYCLE982 Remedy: The position of the cutting edge of the turning tool (cutting tip) is no longer in the machining plane (interpolation plane), this can be caused, for example, by a tool carrier with orientation capability. Correct the tool

Siemens SINUMERIKServo/AxisIntermediate30-60 minutes

61441

Siemens 840D 61441 - Channel block: Position of cutting edge is not in the machining

Channel block: Position of cutting edge is not in the machining

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Common Causes

Tool carrier orientation has shifted the cutting edge position outside the machining plane during CYCLE982 execution
Incorrect tool offset values stored in the tool table for the active tool
Tool carrier mechanical wear or looseness causing unintended position deviation
Spindle orientation or tool holder seating issue resulting in cutting edge misalignment

Troubleshooting Steps

1Verify tool carrier orientation is correct and mechanically secure; inspect for wear or looseness in the tool holder interface
2Check active tool offset values in the tool table and compare against physical tool geometry measurements; update offsets if necessary
3Re-run CYCLE982 measuring cycle after ensuring tool is properly seated and spindle orientation is at expected position
4Review NC program block containing the alarm trigger and verify cutting edge position matches the defined machining plane geometry
5If using an oriented tool carrier, confirm orientation angles match program specifications and recalibrate tool position if needed

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.