What causes Siemens SINUMERIK alarm 61367?

Multiple setpoint variables (_SETV[0...3] or _SETV[4...7]) are configured with identical coordinate values in CYCLE961. Setpoint array parameters overlap or share the same position data across different array indices. Incorrect cycle setup where positioning points are not properly differentiated in the setpoint variable definitions. Parameter configuration error where _SETV indices reference the same machine coordinates.

How do I fix Siemens SINUMERIK alarm 61367?

1. Review the CYCLE961 call in the NC program and examine all _SETV[0] through _SETV[7] parameter assignments for duplicate coordinate values 2. Verify each setpoint variable is assigned a unique position; compare X, Y, Z, and any additional axis values across all defined _SETV indices 3. Consult the machine documentation or cycle definition to confirm the intended purpose and required spacing between each setpoint 4. Modify the NC program to assign distinct coordinate values to each _SETV parameter according to cycle requirements 5. Clear the alarm, reload the updated program, and test the CYCLE961 execution to confirm resolution

Siemens SINUMERIK codes

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 20-45 minutes

Alarm 61367

Siemens 840D 61367 - Channel block: Parameters _SETV[0.3] or _SETV[4.7] are

The alarm is triggerd by the following cycles: CYCLE961. Remedy: Specify different positions for the relevant points of _SETV[0.7].

Siemens SINUMERIKServo/AxisIntermediate20-45 minutes

61367

Siemens 840D 61367 - Channel block: Parameters _SETV[0.3] or _SETV[4.7] are

Channel block: Parameters _SETV[0.3] or _SETV[4.7] are

The alarm is triggerd by the following cycles: CYCLE961. Remedy: Specify different positions for the relevant points of _SETV[0.7].

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Common Causes

Multiple setpoint variables (_SETV[0...3] or _SETV[4...7]) are configured with identical coordinate values in CYCLE961
Setpoint array parameters overlap or share the same position data across different array indices
Incorrect cycle setup where positioning points are not properly differentiated in the setpoint variable definitions
Parameter configuration error where _SETV indices reference the same machine coordinates

Troubleshooting Steps

1Review the CYCLE961 call in the NC program and examine all _SETV[0] through _SETV[7] parameter assignments for duplicate coordinate values
2Verify each setpoint variable is assigned a unique position; compare X, Y, Z, and any additional axis values across all defined _SETV indices
3Consult the machine documentation or cycle definition to confirm the intended purpose and required spacing between each setpoint
4Modify the NC program to assign distinct coordinate values to each _SETV parameter according to cycle requirements
5Clear the alarm, reload the updated program, and test the CYCLE961 execution to confirm resolution

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.