Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 20-45 minutes

Alarm 61267

Siemens 61267 - Block : Plane infeed too large, residual corners remain

In face milling, the plane infeed must not exceed 85 Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKServo/AxisIntermediate20-45 minutes

61267

Siemens 61267 - Block : Plane infeed too large, residual corners remain

Block: Plane infeed too large, residual corners remain

In face milling, the plane infeed must not exceed 85 Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.

Common Causes

  • In face milling, the plane infeed must not exceed 85%

Troubleshooting Steps

  1. 1Select a smaller plane infeed, as otherwise residual corners will be left over.
  2. 2Clear alarm with the RESET key. Restart part program Continuation: Alarms

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.