axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-45 minutes
Siemens 61177 - Block : polar text length > 360 degrees
In the engraving cycle, the polar text length must not exceed 360 degrees Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
61177
Siemens 61177 - Block : polar text length > 360 degrees
Block: polar text length > 360 degrees
In the engraving cycle, the polar text length must not exceed 360 degrees Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- In the engraving cycle, the polar text length must not exceed 360 degrees
Troubleshooting Steps
- 1Enter shorter text length.
- 2Clear alarm with the RESET key. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.