What causes Siemens SINUMERIK alarm 61002?

VARI parameter assigned an invalid or out-of-range numerical value. VARI parameter type mismatch (integer expected vs. string or decimal provided). Incompatible VARI value for the selected machining cycle (e.g., SLOT1, POCKET3). VARI parameter not initialized before cycle call. Incorrect syntax or missing VARI assignment in part program.

How do I fix Siemens SINUMERIK alarm 61002?

1. Review the part program block triggering the alarm and identify which cycle (SLOT1, SLOT2, POCKET1-4, CYCLE71, CYCLE72, CYCLE76, CYCLE77, CYCLE93, CYCLE95, CYCLE97, CYCLE98) is active 2. Check the VARI parameter value currently defined in the program against the cycle documentation to verify it is within the acceptable range for that specific machining type 3. Confirm VARI parameter is declared as an integer type and is assigned before the cycle is called 4. Consult the Siemens 840D/828D cycle reference manual for the specific cycle to determine valid VARI values and their meanings 5. Correct the VARI parameter assignment in the source code, save, and recompile the part program before restarting

Siemens SINUMERIK codes

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 20-45 minutes

Alarm 61002

Siemens 840D 61002 - Channel block: Type of machining incorrectly defined

The value of the VARI parameter for the machining has been incorrectly specified. Alarm triggered by following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, CYCLE71, CYCLE72, CYCLE76, CYCLE77, CYCLE93, CYCLE95, CYCLE97, CYCLE98. Remedy: Modify VARI parameter.

Siemens SINUMERIKServo/AxisIntermediate20-45 minutes

61002

Siemens 840D 61002 - Channel block: Type of machining incorrectly defined

Channel block: Type of machining incorrectly defined

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Common Causes

VARI parameter assigned an invalid or out-of-range numerical value
VARI parameter type mismatch (integer expected vs. string or decimal provided)
Incompatible VARI value for the selected machining cycle (e.g., SLOT1, POCKET3)
VARI parameter not initialized before cycle call
Incorrect syntax or missing VARI assignment in part program

Troubleshooting Steps

1Review the part program block triggering the alarm and identify which cycle (SLOT1, SLOT2, POCKET1-4, CYCLE71, CYCLE72, CYCLE76, CYCLE77, CYCLE93, CYCLE95, CYCLE97, CYCLE98) is active
2Check the VARI parameter value currently defined in the program against the cycle documentation to verify it is within the acceptable range for that specific machining type
3Confirm VARI parameter is declared as an integer type and is assigned before the cycle is called
4Consult the Siemens 840D/828D cycle reference manual for the specific cycle to determine valid VARI values and their meanings
5Correct the VARI parameter assignment in the source code, save, and recompile the part program before restarting

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.