Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 30-120 minutes

Alarm 300722

Siemens 300722 - Axis drive zero-load motor current greater than rated current of

On the basis of its no-load current (MD 1136: $MD_MOTOR_NOLOAD_CURRENT (motor no-load current), the connected motor is too large for the power section in use (continuous thermal current MD 1108: $MD_INVERTER_MAX_THERMAL_CURR (current limit for power section) Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Siemens SINUMERIKServo/AxisIntermediate30-120 minutes

300722

Siemens 300722 - Axis drive zero-load motor current greater than rated current of

Axis drive zero-load motor current greater than rated current of

On the basis of its no-load current (MD 1136: $MD_MOTOR_NOLOAD_CURRENT (motor no-load current), the connected motor is too large for the power section in use (continuous thermal current MD 1108: $MD_INVERTER_MAX_THERMAL_CURR (current limit for power section) Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Safety

  • Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.

Common Causes

  • On the basis of its no-load current (MD 1136: $MD_MOTOR_NOLOAD_CURRENT (motor no-load current), the connected motor is too large for the power section in use (continuous thermal current MD 1108: $MD_INVERTER_MAX_THERMAL_CURR (current limit for power section)

Troubleshooting Steps

  1. 1Please inform the authorized personnel/service department.
  2. 21.
  3. 3Reset the drive (delete the bootfile) and repeat the startup.
  4. 42.
  5. 5Check the configuration and install a suitable power section for the motor.
  6. 6Repeat the startup.
  7. 7Switch control OFF - ON

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.