axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-45 minutes
Siemens 17130 - Block analog output no. not activated
An attempt has been made by means of the system variable $A_OUTA[n] to write or read an analog output n that has not been activated by the MD10310 $MN_FASTIO_ANA_NUM_OUTPUTS Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
17130
Siemens 17130 - Block analog output no. not activated
Block analog output no. not activated
An attempt has been made by means of the system variable $A_OUTA[n] to write or read an analog output n that has not been activated by the MD10310 $MN_FASTIO_ANA_NUM_OUTPUTS Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- An attempt has been made by means of the system variable $A_OUTA[n] to write or read an analog output n that has not been activated by the MD10310 $MN_FASTIO_ANA_NUM_OUTPUTS
Troubleshooting Steps
- 1Please inform the authorized personnel/service department.
- 2Modify part program or machine data accordingly.
- 3Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.