Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-60 minutes

Alarm 15450

Siemens 15450 - Block compiled program cannot be stored

In the compile mode, a compiled program could not be stored. One of the following reasons applies: - Not enough memory - Intermediate code line (compilate) too large Control reaction: Alarm display. Alarms.

Siemens SINUMERIKProgram/G-codeIntermediate30-60 minutes

15450

Siemens 15450 - Block compiled program cannot be stored

Block compiled program cannot be stored

In the compile mode, a compiled program could not be stored. One of the following reasons applies: - Not enough memory - Intermediate code line (compilate) too large Control reaction: Alarm display. Alarms.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • In the compile mode, a compiled program could not be stored.
  • One of the following reasons applies: - Not enough memory - Intermediate code line (compilate) too large

Troubleshooting Steps

  1. 1Create space in work memory or modify part program (make it less complex).
  2. 2Clear alarm with the Delete key or NC START

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.