axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 20-40 minutes
Siemens 12588 - Block motion synchronous action: address not allowed
- The specified address cannot be programmed in motion-synchronous actions. Example: ID = 1 WHENEVER $A_IN[1]==1 DO D3 - The cutting edge cannot be changed out of a motion-synchronous action Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
12588
Siemens 12588 - Block motion synchronous action: address not allowed
Block motion synchronous action: address not allowed
- The specified address cannot be programmed in motion-synchronous actions. Example: ID = 1 WHENEVER $A_IN[1]==1 DO D3 - The cutting edge cannot be changed out of a motion-synchronous action Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- - The specified address cannot be programmed in motion-synchronous actions.
- Example: ID = 1 WHENEVER $A_IN[1]==1 DO D3 - The cutting edge cannot be changed out of a motion-synchronous action
Troubleshooting Steps
- 1Modify part program.
- 2Alarms NCK alarms
- 3Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.