axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 10781 - Block illegal orientation of involute with tool radius compensation
Tool radius compensation is possible for involutes only if the compensation plane matches the involute plane Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.
10781
Siemens 10781 - Block illegal orientation of involute with tool radius compensation
Block illegal orientation of involute with tool radius compensation
Tool radius compensation is possible for involutes only if the compensation plane matches the involute plane Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- Tool radius compensation is possible for involutes only if the compensation plane matches the involute plane
Troubleshooting Steps
- 1Modify part program.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.