axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 840D 105017 - Selection possible only after enable or in RESET state
Siemens SINUMERIK operator message 105017: Selection possible only after enable or in RESET state. This is an informational message from the SINUMERIK control indicating a system status or operation result that may require operator action.
105017
Siemens 840D 105017 - Selection possible only after enable or in RESET state
Selection possible only after enable or in RESET state
Siemens SINUMERIK operator message 105017: Selection possible only after enable or in RESET state. This is an informational message from the SINUMERIK control indicating a system status or operation result that may require operator action.
Safety
- Refer to Siemens documentation
- Ensure qualified technician performs repairs
Common Causes
- Normal system operation generated this status message
- User action or program command triggered this notification
- Machine data or parameter change created this notification
- System startup or initialization process generating a status report
Troubleshooting Steps
- 1Read the full message text displayed on the SINUMERIK screen for complete details.
- 2If action is required, follow the instructions shown in the message.
- 3Consult the SINUMERIK alarm manual for alarm 105017 for detailed information about this message.
- 4If the message appears unexpectedly, check recent parameter changes or program modifications.
- 5For recurring messages, contact Siemens technical support or the machine builder.
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.