105007

Access the NC program editor and check the program header for the program name field (usually following % symbol).

Verify that a valid program name is entered using alphanumeric characters without special characters (underscores are typically allowed).

Avoid using spaces, periods at the start, or reserved system names.

Ensure the program name follows the naming convention specified in your machine configuration (typically 8-24 characters depending on system setup).

Save the program, reset the alarm using the CLEAR key, and attempt to reload or execute the program.

Navigate to the tool management menu (Offset -> Tool List or similar path depending on HMI version).

Check the tool offset table for the tool number being referenced and verify the tool name field is populated.

Tool names must be unique and cannot be left blank if name-based tool management is enabled.

Enter a valid tool name following the format specified in your tool management configuration (typically alphanumeric, may support underscores).

If using tool call in NC program, verify syntax matches tool name format (e.g., T="TOOL_NAME" for name-based calls).

Access the commissioning level (password level 2 or 3) and navigate to Machine Data or Setting Data where recent changes were made.

Ensure you have proper authorization and backup current configuration before making changes.

Review recently modified parameters, particularly those related to axis configuration, channel setup, or user-defined variables that require name identifiers.

Enter the required name or identifier according to Siemens documentation for the specific machine data parameter.

Incorrect naming in machine data can cause system instability or communication errors.

Perform a control system reboot (power cycle) to ensure configuration changes are loaded, then verify alarm is cleared.

Save all active programs and ensure no machining operations are in progress before reboot.