104251

Access machine data and check MD18086 $MN_MM_NUM_MAGAZINE to verify the number of configured magazines (should be 1 if only one magazine exists).

Review MD18088 $MN_MM_NUM_TOOL_MANAGEMENT to confirm tool management configuration matches physical machine setup.

If second magazine is not needed, modify the part program to remove references to magazine 2 or change tool calls to magazine 1.

If second magazine should exist, contact machine tool builder for proper machine data configuration and PLC adaptations required for dual magazine operation.

Incorrect machine data modification can cause system malfunction. Document original values before changes.

Check the PLC diagnostics for magazine status signals and verify both magazines show ready/enabled status in the tool management interface.

Review alarm history for any previous magazine-related errors (1042xx series) that may have disabled the second magazine.

Verify physical magazine presence, power supply, and communication connections to the second magazine if equipped.

Reset magazine system through service screens (Diagnostics > Tool Management > Magazine Reset) and perform magazine reference run if required.

Ensure tool changer area is clear before performing magazine reference operations.

Search part program for SETMS commands or magazine selection syntax that explicitly calls magazine 2 or higher.

Review tool list and check if any tools have magazine assignment to magazine 2 in the tool offset data or tool management tables.

Modify program to use only magazine 1 or update tool data to assign all required tools to the available magazine.

Test program in single block mode after modifications to verify all tool calls access the correct magazine location.