What causes Siemens SINUMERIK alarm 104133?

Part program contains an illegal or unsupported command for the current machine configuration. Parameter or machine data setting incompatible with the commanded operation. Required option or function not enabled on this SINUMERIK control. Incorrect axis assignment or configuration for the commanded function. Software version or compile cycle version mismatch.

How do I fix Siemens SINUMERIK alarm 104133?

1. Note the full alarm message including any parameter values shown (e.g., axis number, block number, channel). 2. Identify the program block or operation that triggered the alarm. 3. Review the SINUMERIK alarm manual for alarm 104133 to identify the specific cause and remedy. 4. Check the relevant machine data parameters referenced in the alarm. 5. If the alarm persists after correcting the program, contact Siemens technical support with the full alarm text and machine data backup.

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 104133

Siemens 840D 104133 - PA: Error on reading cont./JOG mode

Alarm 104133 indicates a parameter access (PA) error when the system attempts to read the continuous/JOG mode setting. This typically occurs when the NC program or synchronized action tries to read operating mode parameters that are either incorrectly addressed, not accessible in the current context, or the PA command syntax is malformed.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

104133

Siemens 840D 104133 - PA: Error on reading cont./JOG mode

PA: Error on reading cont./JOG mode

Root Cause Summary

Alarm 104133 indicates a parameter access (PA) error when the system attempts to read the continuous/JOG mode setting. This typically occurs when the NC program or synchronized action tries to read operating mode parameters that are either incorrectly addressed, not accessible in the current context, or the PA command syntax is malformed.

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Causes and Fixes

1
Identify the NC block number where the alarm occurred. Check the alarm detail display for the block number and line reference.
2
Review the PA command syntax in the identified block. Verify parameter number format (e.g., $PA_xxx) and ensure correct spelling and structure according to Siemens documentation.
3
Verify that the parameter being read is valid for your specific SINUMERIK 840D software version. Check machine data documentation for parameter availability.
4
Correct the PA command syntax or replace with the appropriate parameter identifier. Test the program in single block mode to verify the fix.
Always backup the NC program before making modifications.

Service Recommended confidence

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.