What causes Siemens SINUMERIK alarm 104114?

Part program contains an illegal or unsupported command for the current machine configuration. Parameter or machine data setting incompatible with the commanded operation. Required option or function not enabled on this SINUMERIK control. Incorrect axis assignment or configuration for the commanded function. Software version or compile cycle version mismatch.

How do I fix Siemens SINUMERIK alarm 104114?

1. Note the full alarm message including any parameter values shown (e.g., axis number, block number, channel). 2. Identify the program block or operation that triggered the alarm. 3. Review the SINUMERIK alarm manual for alarm 104114 to identify the specific cause and remedy. 4. Check the relevant machine data parameters referenced in the alarm. 5. If the alarm persists after correcting the program, contact Siemens technical support with the full alarm text and machine data backup.

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 104114

Siemens 840D 104114 - PA: Error on writing notebook

This alarm indicates an error when writing to the notebook/workpiece coordinate system memory in the Siemens SINUMERIK system, typically caused by invalid coordinate system data, memory issues, or incorrect programming of coordinate system functions.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

104114

Siemens 840D 104114 - PA: Error on writing notebook

PA: Error on writing notebook

Root Cause Summary

This alarm indicates an error when writing to the notebook/workpiece coordinate system memory in the Siemens SINUMERIK system, typically caused by invalid coordinate system data, memory issues, or incorrect programming of coordinate system functions.

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Causes and Fixes

1
SAFETY: Stop all machine operations
Ensure machine is in safe state before proceeding with diagnostics.
2
Check coordinate system programming
Review G-code for coordinate system calls (G54-G59) and verify syntax and values are within machine limits.
3
Verify coordinate values
Ensure all coordinate system offset values are within the machine's travel limits and properly formatted.
4
Reset and test carefully
Clear alarm, verify machine position, and test program in single block mode.

Service Recommendedmedium confidence

Call a technician if:

·If alarm involves coordinate system memory corruption
·If machine positioning accuracy is affected
·If alarm persists after program correction
·When system-level memory reset is required

Prevention

Validate programs using simulation before execution
Ensure G-code matches the control's capabilities

Common Mistakes

Overlooking the specific block number in the alarm
Assuming hardware fault instead of program error

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.