What causes Siemens SINUMERIK alarm 103000?

Required machine data or parameter not configured for the requested function. Option bit not set in SINUMERIK to enable the required functionality. Program references a function or axis that has not been configured. Machine commissioning incomplete — required setup step was not performed. Configuration data cleared or lost due to a parameter reset or hardware change.

How do I fix Siemens SINUMERIK alarm 103000?

1. Read the full alarm message to identify what is missing (axis name, parameter number, function name). 2. Consult the SINUMERIK alarm manual for alarm 103000 for the specific configuration requirement. 3. Check the relevant machine data group and set the required parameter. 4. If a specific option is required, verify it is licensed and enabled in the SINUMERIK option settings. 5. Power cycle after making configuration changes to apply the new settings.

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 103000

Siemens 840D 103000 - No correction block in the NCK

Alarm 103000 indicates that the NCK (Numerical Control Kernel) cannot locate the required correction block data, typically needed for tool length compensation (TLC), tool radius compensation (TRC), or work offset data. This occurs when a program calls for correction data that has not been defined in the tool offset table, work offset table, or setting data. The NCK expects specific correction blocks to be present in memory but finds them missing or improperly configured.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

103000

Siemens 840D 103000 - No correction block in the NCK

No correction block in the NCK

Root Cause Summary

Alarm 103000 indicates that the NCK (Numerical Control Kernel) cannot locate the required correction block data, typically needed for tool length compensation (TLC), tool radius compensation (TRC), or work offset data. This occurs when a program calls for correction data that has not been defined in the tool offset table, work offset table, or setting data. The NCK expects specific correction blocks to be present in memory but finds them missing or improperly configured.

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Causes and Fixes

1
Access the HMI and navigate to Tool Offset/Correction table (Parameters > Tool Data > Tool Offset).
2
Verify that the D-number or tool number referenced in the NC program has corresponding offset values entered in the tool offset table.
3
If the offset is missing, create the required tool offset entry and input appropriate geometry and wear values for length and radius.
Ensure values are measured accurately to prevent collisions or part quality issues.
4
Reset the alarm, reload the program, and execute test run in single block mode to verify correction data is accessible.

Service Recommended confidence

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.