Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-60 minutes

Alarm 61019

Siemens 61019 - Parameter incorrectly defined

Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKProgram/G-codeIntermediate30-60 minutes

61019

Siemens 61019 - Parameter incorrectly defined

Parameter incorrectly defined

Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Troubleshooting Steps

  1. 1Check the value of the parameter.
  2. 2Clear alarm with the RESET key. Restart part program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.