Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 4005

Siemens 840D 4005 - Maximum number of axes in channel exceeded. Limit

Siemens SINUMERIK 840D system notice 4005: Maximum number of axes in channel exceeded. Limit. This is a system-level notification regarding machine data or configuration. Note the message details and take the indicated action.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

4005

Siemens 840D 4005 - Maximum number of axes in channel exceeded. Limit

Maximum number of axes in channel exceeded. Limit

Siemens SINUMERIK 840D system notice 4005: Maximum number of axes in channel exceeded. Limit. This is a system-level notification regarding machine data or configuration. Note the message details and take the indicated action.

Safety

  • Refer to Siemens documentation
  • Ensure qualified technician performs repairs

Common Causes

  • Machine data was changed requiring acknowledgment or power cycle
  • System configuration change notification
  • Commissioning or service operation generated this notice
  • Axis or drive configuration change affecting machine data

Troubleshooting Steps

  1. 1Read the complete notice text on the SINUMERIK screen.
  2. 2If a power cycle is indicated, perform a controlled machine power off and restart.
  3. 3If machine data backup is indicated, save the current machine data.
  4. 4Acknowledge the notice and verify the system is operating correctly after the change.
  5. 5Consult the machine commissioning engineer if the notice is unexpected.

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.