Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Basic · 10-20 minutes

Alarm 14195

Siemens 14195 - Block D number with G49

G49 (select tool length compensation) and an D word not equal to D0 have been programmed simultaneously Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.

Siemens SINUMERIKProgram/G-codeBasic10-20 minutes

14195

Siemens 14195 - Block D number with G49

Block D number with G49

G49 (select tool length compensation) and an D word not equal to D0 have been programmed simultaneously Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • G49 (select tool length compensation) and an D word not equal to D0 have been programmed simultaneously

Troubleshooting Steps

  1. 1Modify part program.
  2. 2Clear alarm with NC START or RESET key and continue the program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.