Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Basic · 10-20 minutes

Alarm 14126

Siemens 14126 - Block ORIPATH lift factor impermissible.

The value programmed with ORIPLF = r is not within the permissible range. The relative retraction factor must lie within interval 0 <= r < 1 Control reaction: Correction block is reorganized. Interpreter stop Interface signals are set. Alarm display.

Siemens SINUMERIKProgram/G-codeBasic10-20 minutes

14126

Siemens 14126 - Block ORIPATH lift factor impermissible.

Block ORIPATH lift factor impermissible.

The value programmed with ORIPLF = r is not within the permissible range. The relative retraction factor must lie within interval 0 <= r < 1 Control reaction: Correction block is reorganized. Interpreter stop Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The value programmed with ORIPLF = r is not within the permissible range.
  • The relative retraction factor must lie within interval 0 <= r < 1

Troubleshooting Steps

  1. 1Modify part program.
  2. 2Clear alarm with NC START or RESET key and continue the program. Continuation: Alarms

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.