axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 10982 - Block orientation smoothing not possible with ORISON
This alarm has the following cause: The smoothing of the orientation with ORISON is only possible if MD MD28590 $MC_MM_ORISON_BLOCKS >= 4 Control reaction: Correction block is reorganized. Interpreter stop Interface signals are set. Alarm display.
10982
Siemens 10982 - Block orientation smoothing not possible with ORISON
Block orientation smoothing not possible with ORISON
This alarm has the following cause: The smoothing of the orientation with ORISON is only possible if MD MD28590 $MC_MM_ORISON_BLOCKS >= 4 Control reaction: Correction block is reorganized. Interpreter stop Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- This alarm has the following cause: The smoothing of the orientation with ORISON is only possible if MD MD28590 $MC_MM_ORISON_BLOCKS >= 4
Troubleshooting Steps
- 1Modify part program or set MD28590 $MC_MM_ORISON_BLOCKS >= 3.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.