axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 840D 105061 - Error on opening of file!
Siemens SINUMERIK alarm 105061: Error on opening of file!. This alarm indicates an error condition in the NC program or control configuration that must be resolved before the operation can continue.
105061
Siemens 840D 105061 - Error on opening of file!
Error on opening of file!
Siemens SINUMERIK alarm 105061: Error on opening of file!. This alarm indicates an error condition in the NC program or control configuration that must be resolved before the operation can continue.
Safety
- Refer to Siemens documentation
- Ensure qualified technician performs repairs
Common Causes
- Part program contains an illegal or unsupported command for the current machine configuration
- Parameter or machine data setting incompatible with the commanded operation
- Required option or function not enabled on this SINUMERIK control
- Incorrect axis assignment or configuration for the commanded function
- Software version or compile cycle version mismatch
Troubleshooting Steps
- 1Note the full alarm message including any parameter values shown (e.g., axis number, block number, channel).
- 2Identify the program block or operation that triggered the alarm.
- 3Review the SINUMERIK alarm manual for alarm 105061 to identify the specific cause and remedy.
- 4Check the relevant machine data parameters referenced in the alarm.
- 5If the alarm persists after correcting the program, contact Siemens technical support with the full alarm text and machine data backup.
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.