104243

Review the NC program line where the alarm occurred and identify the magazine number being called (check T-codes, tool change commands, or explicit magazine references).

Access the tool management screen (e.g., via HMI > Machine > Tool Management) and verify the valid magazine numbers configured in the system.

Cross-reference the program's magazine number against the configured magazines. Check MD18100 $MN_MM_NUM_MAGAZINE to confirm the total number of magazines defined.

Modifying machine data may affect multiple operations - document original values before changes.

Correct the NC program to use a valid magazine number within the configured range (typically 1 to the maximum defined magazine count), or add the required magazine to the configuration if needed.

Navigate to the tool management configuration (Commissioning > System Data > Tool Management) and verify that all physical magazines are properly defined with correct numbering.

Check MD18100 $MN_MM_NUM_MAGAZINE and ensure it matches the actual number of magazines on the machine. Verify MD18110 $MN_MM_TYPE_OF_MAGAZINE array for each magazine type definition.

Backup all machine data before modifying MD values.

Review the magazine configuration data files (e.g., MMCA*.INI files) for corruption or missing entries. Compare with a known-good backup if available.

If configuration errors are found, restore the correct magazine parameters, perform a control reboot (POWER ON reset), and reload the tool management data.

Control reboot will interrupt all operations - coordinate with production schedule.

Check if the program uses magazine offsets or indirect addressing (e.g., R-parameters or variables for magazine numbers) and verify the calculated result is within valid range.

Review MD18120 $MN_MM_NUM_MAGAZINE_LOCATION for each magazine to confirm the number of locations matches physical reality and program expectations.

Verify SD42940 $SC_MIRROR_TOOL_WEAR and related setting data that may affect tool/magazine number interpretation during specific operations like mirroring or transformations.

If using custom macros or subprograms for tool management, debug the magazine number calculation logic and ensure all conditional paths produce valid magazine numbers.