What causes Siemens SINUMERIK alarm 104033?

Part program contains an illegal or unsupported command for the current machine configuration. Parameter or machine data setting incompatible with the commanded operation. Required option or function not enabled on this SINUMERIK control. Incorrect axis assignment or configuration for the commanded function. Software version or compile cycle version mismatch.

How do I fix Siemens SINUMERIK alarm 104033?

1. Note the full alarm message including any parameter values shown (e.g., axis number, block number, channel). 2. Identify the program block or operation that triggered the alarm. 3. Review the SINUMERIK alarm manual for alarm 104033 to identify the specific cause and remedy. 4. Check the relevant machine data parameters referenced in the alarm. 5. If the alarm persists after correcting the program, contact Siemens technical support with the full alarm text and machine data backup.

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 104033

Siemens 840D 104033 - Error on Delete cutting edge

Alarm 104033 occurs when the control system encounters an error while attempting to delete a cutting edge definition from the tool management system. This typically happens when referencing a non-existent cutting edge, attempting to delete a cutting edge that is currently active or in use, or when there is a syntax error in the TCDEL command.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

104033

Siemens 840D 104033 - Error on Delete cutting edge

Error on Delete cutting edge

Root Cause Summary

Alarm 104033 occurs when the control system encounters an error while attempting to delete a cutting edge definition from the tool management system. This typically happens when referencing a non-existent cutting edge, attempting to delete a cutting edge that is currently active or in use, or when there is a syntax error in the TCDEL command.

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Causes and Fixes

1
Review the NC program line containing the TCDEL command and note the tool number and cutting edge number being referenced.
2
Access the tool management system and verify that the specified cutting edge actually exists for the tool in question.
3
Check the tool offset table to confirm the cutting edge number is valid (typically D1-D9 or as configured in your system).
4
Correct the NC program to reference an existing cutting edge or remove the TCDEL command if the cutting edge has already been deleted.

Service Recommended confidence

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.